Starlight-xpress Lodestar-C imager/guider User Manual

Browse online or download User Manual for Camcorders Starlight-xpress Lodestar-C imager/guider. Starlight Xpress Lodestar-C imager/guider User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 11
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Lodestar C handbook Issue 1 May 2011
Handbook for the SX ‘Lodestar C’ one-shot colour imager and guide camera
Thank you for purchasing a Starlight Xpress ‘Lodestar C’ CCD camera. We hope that you will be very
pleased with the performance of this product.
The Lodestar C is a very compact imager / guider which is powered and operated via a single USB2.0
computer connection. It also provides an opto-isolated output connection for direct control of most
mounts, via their ‘Autoguider’ sockets. This output is compatible with the ‘ST4’ style of RJ12
connection and supplies 4 ‘pull down’ direction lines and a common return. Alternatively, you may
send the mount control signals via a serial connection from the guider control computer.
The Lodestar utilises a very sensitive Sony ‘ExView’ CCD (the ICX429AK) with an array of 752 x
580 pixels in a ‘half-inch’ format. Although the chip is not cooled, it has a very low dark signal and
very little readout noise, so it can be used to guide on faint stars that are beyond the reach of webcams
and CMOS chip based guide cameras.
The Lodestar specification:
CCD - Sony ICX429AK ExView colour ‘CMYK’ CCD
Pixel count - 752(H) x 580(V)
Pixel size - 8.6 x 8.3uM
Barrel size - 32mm dia. x 72mm long (1.25 inch eyepiece push fit size)
Barrel thread - 25.4mm x 0.75mm ‘CS’ mount lens thread
Input connection - ‘Mini B’ USB socket for USB2.0
Output connection - 5 way JST ‘ZH’ style 1.5mm pitch plug to RJ12 autoguider plug
Output type - Opto-isolated 4 lines (N,S,E & W) pull down with common return line
Download rate - Approx. 5 frames per second in full resolution 1x1 mode
Installing the Lodestar software:
A new installation will require the driver files SXVIO.sys and Generic.sys, plus the
SXVIO_Lodestar.inf file. If you run the ‘Setup.exe’ file on the supplied CD, it will install the drivers
and operating software automatically. If you are installing manually, copy these files into a convenient
folder on drive C and then connect the USB cable to the Lodestar. Point the installer at this folder when
Page view 0
1 2 3 4 5 6 ... 10 11

Summary of Contents

Page 1

Lodestar C handbook Issue 1 May 2011Handbook for the SX ‘Lodestar C’ one-shot colour imager and guide cameraThank you for purchasing a Starlight Xpres

Page 2

Lodestar C handbook Issue 1 May 2011After a brief delay, the Guiding Info window will open, as above, and you will see the guide star, alongwith error

Page 3

Lodestar C handbook Issue 1 May 2011Dear User,Thank you for purchasing a Starlight Xpress CCD Imaging System. We are confident that you will gainmuch

Page 4

Lodestar C handbook Issue 1 May 2011it asks for the location of the drivers and you should see it set up the hardware as a ‘BlockIOClass’device in Dev

Page 5 - The raw image:

Lodestar C handbook Issue 1 May 2011be very ‘washed out’ (chlorophyll reflects infrared very strongly). Also, the infrared focusing of manylenses and

Page 6

Lodestar C handbook Issue 1 May 2011image and confirming that the colours are essentially correct when using this setting. If the colours arebadly wro

Page 7

Lodestar C handbook Issue 1 May 2011The settings shown in the picture are generally suitable for getting the best results, so try these first.Here is

Page 8

Lodestar C handbook Issue 1 May 2011After colour conversion and some power law contrast stretching:Post processing of your images is necessary, if you

Page 9

Lodestar C handbook Issue 1 May 2011The Lodestar C attached to an 80mm F5 guide ‘scopeThe focal length of your guide telescope is not especially criti

Page 10

Lodestar C handbook Issue 1 May 2011focal length guide ‘scope, as it offers somewhat finer RA guiding resolution in the X axis if this isoriented East

Page 11

Lodestar C handbook Issue 1 May 2011The image box will be empty at this point, but we need a frame to select the guide star from, so use theguiding op

Comments to this Manuals

No comments